Now that we have the top removed from the Disk
Station, we can go ahead and install the hard drives. Physically attaching the
hard drives is as easy as mounting them into a PC.
Since they are SATA hard drives, each drive will
require its own data port. Synology also decided to give each drive its own
power port too, rather than daisy chain them together.
Once the drives are mounted, you're
pretty much all done inside. The manual makes no mention of advanced settings
that can be configured with the jumper block we can see on the far left side of
the PCB, so at this point we just put the top back on the unit, and proceed to
the next step.
